Dolphin Automatic Electronic Equipment Protector

Dolphin Automatic Electronic Equipment Protector

vendor-unknown

  • Rs.1,499.00


ApplicationThe Dolphin is designed to protect Electronic Equipment against the hazards of over-voltage and over-current caused by under-voltage. The fully automatic operation of the protector now enables its use at places where ordinary circuit breaker could not be used, because of tripping problems. Dolphin protects against short circuit before it occurs.FUNCTIONAL DESCRIPTIONSThe Dolphin Electronic Equipment Protector comes in an ergonomic direct-mounting palm size case.Dolphin supplies power to the equipment as long as the line voltages remain between 165V and 265V. In case the line voltage falls below 165V and stays there for longer than 0.3 seconds continuously, the supply to the equipment will be cut-off. The Dolphin will automatically resume supply to the load once the line volts are normal. No manual intervention is needed.Similarly, if the line voltage rises above 265V and stays there for longer than 0.3 seconds continuously, the supply to the equipment will be cut-off. Again, automatic resumption of supply to the load will take place after the line voltage is normal. However it will wait for approximately 10 seconds to protect the equipment. If power is resumed after more than 10 seconds. The protector will wait for 1.5 seconds only to prevent power back surges reaching the equipment. Reset time varies with the nature of fault, i.e. bigger voltage dip causes a longer time.One unique feature of the design is inverse delay response characteristic. The tripping time of 0.5 second reduces proportionally to the depth of under-voltage or the height of over-voltage.LED INDICATIONNORMAL (GREEN)When green light illuminates, it indicates that Dolphin (AAP) detects a normal Line voltage.FAULT (RED)The light indicates Dolphin (AAP) is protecting your Air Conditioner from a damaging over/under voltage condition.BLINKING (RED)After your Dolphin (AAP) has detected a damaging voltage it has delayed the resumption of power supply for approx. 180 sec. to protect the compressor motor.LED INDICATIONNORMAL (GREEN)When green light illuminates, it indicates that Dolphin detects a normal Line voltage.FAULT (RED)The light indicates Dolphin is protecting your equipment from a damaging over/under voltage condition.BLINKING (RED)After your Dolphin has detected a damaging voltage it has delayed the resumption of power supply for approx. 10 seconds to protect your equipment from power back surges.SPECIFICATIONSELECTRICALOperating Range 155 to 280 V acMaximum Load 1000VA / 5 AUnder-voltage Trip 165V acUnder-voltage Reset 8V acOver-voltage Trip 265V acOver-voltage Reset 5V acTriping Time 0.3 sec.Reset Time approx.* 7~10 sec.* Reset time varies with the nature of faultPHYSICALColor Beige, GreyDimensions 118 x 77 x 39 mm(Excluding Wire)Weight 270 g (approx.)Operating temperature 0OC to 60OCStorage temperature 10 to 80%TROUBLE SHOOTINGIf your protector does not turn the equipment ON then check the following before contacting the dealer.LED IS OFF Power supply is not present. There is some problem with the socket.LED Permanently red Supply voltage is out of range.LED Green Output Refrigerator & Deep Freezer cable connection not proper.Cyclic Tripping (Protector trips again and again) Wiring is not proper for theload. Please check with a qualified electrician to replace wiring and avoid the risk of fire caused by short circuit.ONE-YEAR WARRANTY